Liebherr UIK 1550 Premium - Manual (Page 7)

u Pay attention that the ventilation slots are unobstructed: If
necessary, cut away the unit plinth accordingly!
u To fix the plinth panel: Insert the bolts Fig. 10 (9) , while
keeping firm hold of the plinth panel.
To secure appliance in the recess:
For installing the appliance under a granite worktop, a
fastening set for lateral fixation is available from After Sales
Service.
Fig. 12
u Secure the appliance at the top using long Spax screws
Fig. 12 (19) .
4.3.2 Fitting the unit door
u Fit the handle on the unit door.
Note
To ensure uniform extension of the pull-out compartment:
u Always fit the unit door handle to the middle of the unit door.
Fig. 13
u Check 8 mm presetting. (Distance between appliance door
and lower edge of crosspiece)
u Push up assembly aids Fig. 13 (12) to unit door height.
Lower edge ▲of the assembly aid = top edge of the unit
door to be fitted.
u Unscrew fastening crosspiece Fig. 13 (11) by undoing the
locknuts Fig. 13 (10) .
Fig. 14
u Attach fastening crosspiece Fig. 14 (11) to the inside of the
unit door using the assembly aids Fig. 14 (12) .
u Centre fastening crosspiece Fig. 14 (11) : mark a short
centre line on the unit door and place the tip of the cross-
piece arrow over it.
w Distances to the outer edge are equal at the left and right.
For chipboard doors:
u Secure the fastening crosspiece Fig. 14 (11) with at least 6
screws Fig. 14 (19) .
For frame and panel doors:
u Secure the fastening crosspiece Fig. 14 (11) with 4 screws
Fig. 14 (19) at the edge.
u Raise the assembly aids Fig. 14 (12) for removal, turn them
and insert them into the adjacent openings.
Fig. 15
u Attach the unit door to the adjusting bolts Fig. 15 (13) and
loosely screw the locknuts Fig. 15 (10) onto them.
u Close the door.
u Check the gap between the door and the surrounding unit
doors.
u To laterally align the door: push unit door in X direction.
u To align the door vertically Y and in the lateral inclination:
adjust adjusting bolts Fig. 15 (13) with a screwdriver.
w The unit door is flush and in alignment with the surrounding
unit fronts.
u Tighten locknuts Fig. 15 (10) .
Fig. 16
u To screw the unit door to the appliance door:
Putting into operation
* Depending on model and options 7