Liebherr UIK 1550 Premium - Manual (Page 6)

Fig. 6 for recess height 820 or 870 mm
A = Height of recess
B = Height of unit plinth
C = Height of unit door
D = Base height of cut-away unit plinth
Recess
height A
Height of unit
plinth B
Height of unit
door C
Base height of
unit plinth D
820 mm 100 mm 716 mm 100 mm
820 mm 170 mm 646 mm 100 mm
870 mm 150 mm 716 mm 150 mm
870 mm 220 mm 646 mm 150 mm
Note
u Before assembling the door of the unit, make sure that the
admissable weight of the unit door is not exceeded.
u Otherwise damage to the telescopic rails and resultant
malfunction cannot be ruled out.
Model
Max. weight of unit
door
UIK 10 kg
4.3.1 Installing the appliance
u Detach the connecting cable from the rear of the appli-
ance, removing the cable holder at the same time
because otherwise there will be vibratory noise!
u Lay the connecting cable with
the help of a string in such a
way that the appliance can be
easily connected after fitting.
Fig. 7
Slide in and align the appliance:
NOTICE
Risk of harm to flooring susceptible to damage!
u Place a strip of cardboard under the height-adjustable feet,
approx. 10 cm x 60 cm, one at either side. Cut the strips out
of the packaging. For opening heights less than 826 mm,
use strips of a firm but thin material.
u After the appliance has been slid in, remove the strips.
Fig. 8
u Pull the plinth panel forwards to remove it.
u Slide the appliance
into the recess.
w The distance of the
front edge of the
side wall of the
kitchen unit to the
appliance body is
41.5 mm all the
way round.
Fig. 9
For units with door stop components (knobs, sealing
lips etc.):
u Deduct the extra dimension (depth of the door stop compo-
nents) from the 41.5 mm depth of insertion.
u Align the appliance by adjusting the feet so that it stands
straight: Extend the rear height-adjustable feet by turning
the screws Fig. 8 (3) . If the front height-adjustable feet are
extended, turn them using a screwdriver. If the front height-
adjustable feet are retracted, then extend them using an 8
mm Allen key. The appliance should be slightly clamped in
the recess, between floor and worktop!
Fig. 10
u Insert foam element Fig. 10 (8) - functionally important for
separate air currents!
u Re-attach the plinth panel Fig. 10 (2) and pull it forwards
until the front edge of the ventilation grille and the unit plinth
are planar!
Fig. 11
Putting into operation
6 * Depending on model and options