Liebherr LTM 1200-5.1 User Manual

Page 9

PN 1200-5.1_D-GB/F/I/ESP/RUS 03.07.2007 10:09 Uhr Seite 3

Probedruck

CY CMY

LTM 1200-5.1

Axles 3, 4 and 5 set up as "active rear-axle steering, 5 steering
methods are preselectable by fixed programs (P):

P1 On-road steering
Axles 1 and 2 are steered mechanically with hydraulic assistance
by the steering wheel. Axles 3, 4 and 5 are steered “actively”
speed-dependent according to the cramp of the front axles,
and over 30 km/h, axles 3 and 4 are set to straight displacement
and fixed, from 60 km/h, axle 5 is fixed equally to straight
displacement. The change of the steering angle in accordance
with the speed, results in a precise and stable driving quality
during higher speeds, tyre abrasion is reduced and the
maneuverability clearly improved.

P2 All-wheel steering
Axles 3, 4 and 5, dependent on the steering angle of axle 1
are cramped by means of the steering wheel so that the
smallest turning radii can be performed.

P3 Crab steering
Axles 3, 4 and 5 are cramped into the same direction as axles
1 and 2 by means of the steering wheel.

P4 Steering without swerving
Axles 3, 4 and 5 are cramped in accordance with axle 1 so
that no swerve out of the rear of the carrier takes place.

P5 Independent rear-axle steering
Axles 1 and 2 are cramped by the steering wheel, axles 3, 4
and 5 steered independent of the cramp of axles 1 and 2 by
momentary-contact buttons, whereby the cramp of axle 3 is
adapted to the required situation.

• A failure in the rear-axle steering does make it ineffective

and the rear axles are set to straight displacement by the
centering rams

• Two independent hydraulic circuits with wheel- and engine

driven hydraulic pump, thus maximum safety standard

• Two independent control processors (by existing E/A modules)

and diversified sensoriel system

• Entire know-how of the "active rear-axle steering" by Liebherr

Variable steering concept with
"active rear-axle steering"

• Standard application programs: Safe load indicator (LMB),

configuration program with configuration picture, operation
program with operating picture, telescoping program with
telescoping picture, test parameter program, test system;
supporting force indication and work area limitation as an
optional feature

• Setting of the configuration program by convenient interactive

functions

• Safe and reliable acknowledgement of the configuration set
• Representation of all essential data by graphic symbols on

the operation picture

• With integrated wind force test
• Reliable cutoff device when exceeding the admissible load

moments

• Load capacity values for any boom intermediate length
• Winch indications for precise lifting/lowering of the load

LICCON configuration and
operation program

• Telescoping by single-stage hydraulic ram with hydraulic

driving tenons (patented internal interlocking system)

• Telescoping procedure controllable by convenient operator’s

guide on the monitor, precise approach of the interlocking
positions

• Telescopable loads are displayed on the LICCON operating

picture

• Rapid-cycle telescoping system with "automatic mode", i.e.

all-automatic telescoping to the required boom length

• Very compact and light-weight telescoping system, thus

increased load capacities, especially with long booms and
large radii

• Automatic cushioning in end positions during telescoping

and retracting for the preservation of the structural members

LICCON-assisted telescoping system