Liebherr GGPv 6590 ProfiPremiumline - Manual (Page 11)

23
Adjusting the alarm delay
> A14= 0 Min.
P Alarm Delay
> A14= 0 Min.
0 Min.
Use buttons and to select the desired setting.
Save by pressing the button.
Return to the standard indication by pressing the button.
Note
When in standard display mode, it is possible to switch between
product sensor, standard temperature sensor, both sensors and
date/time using the
button.
> Frozen food
Product
- - °C
> Frozen food
Temp.
- - °C
> Temp. - - °C
Product - - °C
> DD/MM/YY
hh:mm:ss
GB
flashes
Cleaning
Clean the appliance at least twice per year.
Before cleaning always switch off the appliance. Pull out
the mains plug or switch off or unscrew the fuse.
• Empty the appliance and store the food in a cool place.
• Clean the inside and equipment with lukewarm water and a lit-
tle detergent. Do not use abrasive or acid cleaners or chemical
solvents.
Do not use steam cleaners because of the
risk of injury and damage.
• Ensure that no cleaning water penetrates into the electrical
components or ventilation grille.
• Dry all parts well with a cloth.
• Use a commercially available stainless-steel cleaning agent for
stainless-steel appliances.
Do not use abrasive sponges or scourers, do not use con-
centrated cleaning agents and never use cleaning agents
containing sand, chloride or acid or chemical solvents, as
these would damage the surfaces and could cause corro-
sion.
Malfunctions
You may be able to rectify the following faults by checking
the possible causes yourself:
• Appliance does not function:
– Is the appliance switched on?
– Is the plug correctly fitted in the mains socket?
– Is the fuse intact?
• The temperature is not low enough:
– Is the temperature setting correct (see "Setting the tempera-
ture")?
– Have excessive amounts of fresh food been placed in the appli-
ance?
– Does the separately installed thermometer show the correct
reading?
– Is the ventilation system working properly?
– Is the appliance set up too close to a heat source?
If none of the above causes
apply and you cannot rectify
the fault yourself, contact the
nearest customer service de-
partment stating the type desig-
nation 1 , service number 2
and appliance number 3 as
indicated on the type plate.
The position of the type plate
is shown in the section entitled
Description of the appliance.
Shutting your appliance down
If your appliance is to be shut down for any length of time, switch
it off and disconnect the plug or switch off or unscrew the fuse.
Clean the appliance and leave the door open in order to prevent
unpleasant smells.
The appliance complies with the relevant safety regulations and
EC Directives 2004/108/EC and 2006/95/EC.
Cleaning the dust filter
Clean the dust filter at least twice
per year!
Remove the plug!
1. Remove the dust filter by
lifting upwards.
2. Clean the dust filter with
water and detergent.
3. Reinstall the dust filter.