Liebherr GGPv 6590 ProfiPremiumline - Manual (Page 10)

22
Adjusting the alarm limits
> A12= - 45 °C
P low Alarm
> A12= - 45 °C
- 45 °C
Use buttons and to select the desired setting.
Save by pressing the button.
> A13= 45 °C
P high Alarm
> A13= 45 °C
45 °C
Use buttons and to select the desired setting.
Save by pressing the button.
If an alarm delay needs to be set, carry out the steps in the next
section or return to the default display by pressing the
button.
Product sensor settings
• Connect the appliance to the mains - the display reads OFF .
> Frozen food
Product
- - °C
> Menu 01
Setpoint
> Menu 06
Settings
> Settings 01
Service
> Settings 09
Alarm setting
> Sensor check
OFF
> Sensor check
OFF
> Sensor check
ON
Save by pressing the button.
The sensor is now monitored by the electronic control system. In
the event of a sensor error, an alarm will be signalled.
Product sensor
(available accessory)
The temperature may be measured or recorded at any point in
the interior using the product sensor.
2.
Undo the screw on the underside
of the front panel. Tilt the front
panel upwards.
Remove the plug!
1.
Feed the sensor through the opening
in the compressor compartment
and position inside the ap-
pliance.
Seal the opening
with sealant.
3.
Plug in the product sensor
plug.
4.
Close the front panel and fix with the screw.
flashes
flashes
flashes
flashes