Brother DCP 9040CN - Manual (Page 13)

Setting Up the Machine
11
4 Install the power cord
1
Make sure that the machine’s power switch is
off. Remove the label covering the AC power
inlet.
2
Connect the AC power cord to the machine.
3
Plug the AC power cord into an AC outlet. Turn
the power switch on.
5 Selecting your language
1
After turning the power switch on, the LCD
shows:
Select Language
Press OK Key
Press OK.
2
Press or to choose your
language and
press OK.
Select ab or OK
English
3
The LCD prompts you to confirm your
selection.
English?
1.Yes 2.No
If the LCD shows the correct language,
press 1.
—OR—
Press 2 to go back to step
2 to select the
language again.
Note
If you have set the wrong language, you can
change the language from the control panel menu
of the machine. (For details, see “How to change
LCD language” in Chapter C of the User’s Guide.)
6 Setting the LCD contrast
You can change the contrast to help the LCD look
lighter or darker.
1
Press Menu.
2
Press 1.
3
Press 6.
4
Press to increase the contrast.
—OR—
Press
to decrease the contrast.
Press OK.
5
Press Stop/Exit.