BT Converse 2-line Telephone - Manual (Page 10)

The ringer volume switch is located on the
side of your Converse 2-Line and affects
the volume at which your phone rings.
There are three settings
HI – a loud ring. Your phone is pre-set to
this position.
LO – a quiet ring.
OFF – no ring.
Providing batteries are fitted,
your Converse 2-Line will display
the time, day, month and day of
the week.
Press buttons in order shown
Press the FUNCTION button.
Display flashes the month. Enter
the correct month by using the
DIAL
keypad, eg: January = 01,
December = 12.
Fu
nction
DIAL
The date now flashes. Enter the
correct day by using the keypad,
e.g.: 09 = 9th. Please note for
Feb 29th you will need to reset.
DIAL
The day of the week now flashes.
Enter the correct day by using
the keypad, e.g.: 1= Sunday,
7 = Saturday.
DIAL
AM now flashes. Enter the correct
setting. 1= AM, 2 = PM.
DIAL
Display now flashes
TIME. Enter
the correct time by using the
keypad, e.g.: 0515 = 5.15.
The display gives you 15 seconds
to complete each setting. If you
do not press any button in that
time, the display returns to
normal and you must start again
from the beginning.
7
7 Set the time and date
6 Set the ringer volume
Please note
When one line is being used and a call
comes in on the other line, the volume of
the ringer is automatically reduced.
Your Converse 2-Line is now ready for use.
01-01 12:00
AM
LOWER
SU
07-18 12:00
AM
LOWER
SU
07-18 12:00
AM
LOWER
TH
07-18 12:00
AM
LOWER
TH
07-18 05:15
AM
LOWER
TH