Black & Decker CYCLONE BLC12600BUC - Manual (Page 6)

0
PROBLEM POSSIBLE CAUSE SOLUTION
Jar base bottom does A vacuum has been Place the jar on the
not come off of jar. formed. blender and turn
counterclockwise until
jar is released from the
jar base.
liquid is leaking Gasket is either missing Check that jar is
from bottom of jar. or not in place correctly. assembled correctly.
Appliance does Appliance is not Check that appliance
not turn on. plugged in. is plugged into
a working outlet.
Mixture in blender Not enough liquid in Turn the blender off
does not seem to mixture being blended and use a rubber
be blending. or too much ice. spatula to redistribute
the food; add some
liquid and PUlSe the
mixture to aid in the
blending process.
Herbs or bread are Blending jar, food to be Always make sure that
sticking to sides of chopped and blade are the jar, the blade and
blender and not not dry. the food to be chopped
getting chopped. are dry.
Jar separates from Jar was twisted when When removing jar
jar base when being being removed from from blender base,
removed from base of blender. simply lift up; do
blender. liquid not twist.
spills onto counter.
TROUBLESHOOTING
ENGLISH
Care and Cleaning
This product contains no user serviceable parts. Refer service to qualified
service personnel.
CLEANING
1. Before cleaning, turn off and unplug the appliance.
2. To remove the jar, using both hands, grasp the handle with one and the base
of the jar with the other, turn slightly counterclockwise to unlock position and
lift up.
3. Remove jar base by turning it counterclockwise until loose.
4. Remove the gasket and the blade assembly.
Caution: Blades are sharp, handle carefully.
5. Remove lid and lid cap.
6. Wash removable parts by hand or in the dishwasher. Place the jar on the
bottom rack and the rest of the parts on the top rack only.
Helpful Tips:
• For quick cleanup, combine 1 cup hot water and a drop of liquid dish soap
in the blending jar.
• Cover and blend on CleAN for about 30 seconds.
• discard liquid and rinse thoroughly.
Important:
• do not place the jar parts in boiling liquids.
• do not immerse the base in liquid. Wipe the base with a damp cloth and dry
thoroughly.
• Remove stubborn spots by rubbing with a damp cloth and nonabrasive
cleaner.
Note: If liquids spill onto the base, wipe with a damp cloth and dry thoroughly.
do not use rough scouring pads or cleansers on parts or finish.