Bissell PET HAIR ERASER 3920 - Manual (Page 5)

w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
A
ssembly
the only tool you’ll need to assemble
your vacuum cleaner is a Phillips
screwdriver.
Attach handle to vacuum
1. Locate the handle and cord wrap.
Remove the screw packet taped to the
handle.
2. Stand the vacuum upright and from the
rear of the unit, slide the base of the
handle firmly into the grooves at the top
of the vacuum body.
3. IMPoRtAnt – before inserting the
screws into the handle, slide the cord
wrap into the handle.
4. Ensure that the handle and cord wrap fit
firmly to the vacuum body. If there are
any gaps, continue to push firmly until
the handle and cord wrap are flush.
5. Insert 2 of the screws provided (3 total)
into the existing holes, attaching the
cord wrap and handle to the body of the
vacuum. Tighten securely with a Phillips
screwdriver.
6. Attach the hose and cord clip by snap-
ping it into the handle of the unit. Secure
it by inserting the screw provided.
7. Attach the lower hose clip by snapping it
into place and twisting to the right.
5
Curved
Hose
Wand
Hose
Wand
Base
cAutIon:
Do not plug in your vacuum
cleaner until you are
familiar with all instructions
and operating procedures.
2.
6.
3.
WARnIng:
Plastic film can be dangerous.
To avoid danger of suffocation,
keep away from babies and
children.
7.
Hose Clip