Bissell PET HAIR ERASER 3920 - Manual (Page 14)

w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
M
aintenance and care
14
Replace lightbulb
1. Unplug the vacuum from electrical outlet.
2. Using a flat bladed screwdriver, pry the
tab on the left and right side out and pull
out to remove the lens.
3. Remove the bulb from the socket by
grasping the bulb and pulling gently.
Install the new bulb by pushing it gently
into the socket until the bulb snaps into
place.
4. Reposition the lens and snap it back
into place.
Maintaining Pet turboBrush ®
the Pet turboBrush should be checked
regularly for clogs or debris wrapping
around the brush.
1. Unplug the vacuum from electrical outlet.
2. If a clog is present or debris is visible,
unscrew the two screws on the back of the
TurboBrush to remove the faceplate and clear
any obstructions.
3. To clean debris from the brush, remove the
brush from the drive belt and clean debris.
4. Reposition the drive belt on the brush.
Place ends of brush in slots on sides.
Reposition faceplate and secure with two
screws.
notE: this tool is designed to
remove pet hair from upholstered or
carpeted surfaces. It should not be
used on pets.
2.
3.
4.
Pet TurboBrush ®
Pet TurboEraser ™