beautypg.com

Programming the brewer (cont.) – Bunn DUAL068000 User Manual

Page 23

background image

Page 23

PROGRAMMING THE BREWER (cont.)

SET PREINFUSION:

This function sets the brewer to turn the sprayhead

flow on for a preset time (1st ON TIME) followed by a

preset spray pause (OFF TIMES) and then turn the spray

on continuously until the brew volume is completed.

This is a special case of pulse brew. It is not pos-

sible to set a batch size to have both pulse brew and

preinfusion. One or the other (or neither) must be

chosen. However, it is possible to set one batch size

to pulse brew and the other two to preinfusion or vice

versa.

NOTE: The procedure to enter the PULSE BREW

function must be performed prior to following the

steps listed below.

1. Press and release YES. The display should now

read EASY PULSE SETUP.

2. Press and release NO. The display will read ENTER

TIMES?

3. Press YES to proceed. The display should now

read 1st ON TIME X:XX.

4. Using (-) and (+) set the amount of time the flow

of water into the funnel will be on.

5. When finished, press DONE. The display will now

read OFF TIMES: X:XX.

6. Using (-) and (+) set the amount of time the flow

of water into the funnel will be off.

7. When finished, press DONE. The display will now

read LAST ON: PreI

8. If the display shows a time use (-) and (+) to set

it to read PreI. (PreI is an abreviation for preinfu-

sion)

9. When finished, press DONE. The display will show

the two settings and PreI just entered for that batch

size. After a 5 second delay, the display will read

3 BATCHES DONE?

10. If other batch sizes need to be modified, press

NO.

12. Press a different batch size pad and repeat steps 3

through 7. Repeat until all the desired batch sizes

are set.

13. When finished press YES in 3 BATCHES DONE?.

The display will then read DRIP TIME.

14. Press and release the ON/OFF switch (either on

DUAL brewers) located on the front switch panel

to exit the SET PULSE BREW function and return

to the MAIN SCREEN.

NOTE: Pressing the upper right hidden switch before

reaching the final setting screen exits the setup and

retains the old values.

ENTER TIMES?

NO

YES

SET PULSE BREW?

NO

YES

EASY PULSE SETUP

NO

YES

1st ON TIME X:XX

(-) DONE (+)

1st

OFF

LAST

XX.X XX.X

Prel

5 SEC. DELAY

OFF TIMES: X:XX

(-) DONE (+)

3 BATCHES DONE?

NO

YES

EXIT TO

NEXT FUNCTION

SCREEN

LAST ON: Prel

(-) DONE (+)

EXIT TO

NEXT FUNCTION

SCREEN

41342 080108