Bunn 2 - Manual (Page 3)

26. Slide PAF assembly
forward. 27. Reassemble and in-
stall all PAF parts. Close
Door. 28. Position the Faucet
Seal and Return Spring in
the Faucet Valve. 29. Slide the Faucet Valve
assembly into place on
the Hopper. 30. Press down on the
Valve to compress the
Spring. Position the Fau-
cet Handle over the Fau-
cet Valve one side at a
time and snap into place
on the Hopper.
31. Install the Drip Tray
and Cover.
1. Open the Cabinet Door
and allow the support
arms to lock in place.
THOROUGH CLEANING OF THE PAF HOPPER (Once a week)
2. Remove the Hopper/
Base Assembly from the
Cabinet. Remove the
Cover and empty the con-
tents. 3. Pull the Ejector Elbow
off the Hopper Base. Re-
move the Slide Gate from
the Ejector Elbow. 4. Remove the Wiper
Blade and Drive Gear by
removing the Retaining
Ring from the Wiper
Blade Shaft. 5. Remove Auger by pull-
ing it out the front of Hop-
per Base.
6. Remove the Auger
Drive Shaft by removing
Retaining Clip from Auger
Drive Shaft. 7. Wash all components in a
mild solution of dish deter-
gent using a bristle brush
when needed. Rinse and dry
each item thoroughly before
reassembling.
35113 111302