Caution, Ssembly 6, Peration – Bissell 3750 SERIES-220-240V EN User Manual

Page 6

Combination

Tool

Telescoping

Wand

Crevice Tool

TurboBrush

™

Attach vacuum hose and tools

1. Position the Twist 'n Snap hose assembly on

the vacuum and line up the tabs on the base

of the hose with the corresponding notches.

Turn the Twist 'n Snap hose to the right to

lock into place.

2. Slide the end of the hose grip onto the hose

grip base. Place the hose into the hose clip.

notE: the powerfoot will not operate

effectively unless the hose is firmly

attached to the base.

3. Snap the telescoping extension wand,

crevice tool, and combination tool into the

storage clips as shown.

4. On board TurboBrush

™

(select models only).

The TurboBrush bracket slides onto the

hanger on the front of the handle. Attach the

bracket by aligning the slots with the

rectangular part on the hanger as shown

and pulling down until it is locked into place.

notE: If you do not wish to store the

turbobrush on your lift-off vacuum, the

bracket may be hung on a wall for storage and

hanger may be removed from the vacuum.

Place the TurboBrush in the bracket by

aligning the small holes near the brush roll

with the tabs at the bottom of the bracket

and snap the TurboBrush into place.

Power switch/brush switch

the power switch is located just below the

handle on the front of the detachable cylinder.

push the rocker switch “on” (I) to vacuum, and

“off” (o) when cleaning is complete.

ssembly

w w w . b i s s e l l . c o m

caUtIon:

before using your vacuum,

make sure that the dirt

container and upper tank are

in locked position and that all

filters (upper tank, pre-motor

and post-motor) are in place.

Do not operate your vacuum

without these filters.

peration