Bissell 3750 SERIES-220-240V EN - Manual (Page 11)

11
w w w . b i s s e l l . c o m
Upper
Tank
Knob
Cleaning the upper tank & filter
Use only bISSEll replacement filters in your
bISSEll lift-off.
1. Unplug the cleaner from electrical outlet.
2. The upper tank filter can be reached by
removing the dirt container, reaching
underneath the upper tank and turning the
rim of the filter frame to unlock. Pull straight
down to remove. Brush the dirt off the
louvers and upper tank filter.
3. The foam upper tank filter may be removed
and hand washed in cold water with mild
detergent. Rinse well then air dry thoroughly
before replacing.
4. The upper tank and louvers may also be
wiped clean with a damp cloth.
notE: for easier access, the entire upper
tank may be removed by turning the knob
on the back of the cleaner to unlock and
pulling the entire tank straight out.
Cleaning the pre-motor & post-motor filters
Use only bISSEll replacement filters in your
bISSEll lift-off.
1. Unplug the cleaner from electrical outlet.
2. The pre-motor filter protects the motor from
dirt particles. It is located in the slide out
ray underneath the dirt container. If the filter
becomes dirty, pull out the tray, lift out the filter
and clean. This filter may be hand washed in
cold water with mild detergent. Rinse well and
air dry thoroughly before replacing.
3. The HEPA media post-motor filter assists in
the filtration process to return clean air to
the room. It is located behind the door on the
back of the cleaner. If the filter becomes dirty,
open the door, remove the filter and replace.
The HEPA media filter is not washable.
M
aintenance and care
IMpoRtant:
to maximize your cleaning
performance and extend the
life of your vacuum, it is
very important that you
check and clean your
filters frequently.
WaRnInG:
Do not operate cleaner with
damp or wet filters or without
all filters in place.
Pre-Motor Filter
HEPA Media
Post-Motor
Filter