Bloomfield SS2 Series - Manual (Page 15)

PROGRAMMING INSTRUCTIONS (continued)
13
PRECISE BREWING
TEMPERATURE™:
The brew cycle will not start
until the water in the tank is at
the proper temperature.
If START BREW key is pressed
and held for 3 seconds during
“Brew Wait” the brew will
proceed immediately.
Note: the following safety
features prevent multiple
unattended brews:
When the BREW LED is on or
flashing, repeated pressing of
the START BREW switch will be
ignored, (there will be a beep
each time it is pressed).
A Brew will only be activated or
put in Brew Wait when the
BREW LED is off.
Only one brew can be stored in
“Brew Wait” at a time.
FEATURES
1. Energizing the Brewer: Turn the brewer on by pressing the
POWER key. The brewer will start to fill the tank with the
message on the screen “filling…”. With the proper water
supply the tank should be filled in about 2½ minutes. Once