Belkin F5D5231-4 - Manual (Page 28)

26
ALTERNATE SETUP METHOD
Setting your ISP Connection Type to Point-to-Point Protocol over Ethernet (PPPoE)
Most DSL providers use PPPoE as the connection type. If you use a DSL modem
to connect to the Internet, your ISP may use PPPoE to log you into the service.
If you have an Internet connection in your home or small office that doesn’t
require a modem, you may also use PPPoE.
Your connection type is PPPoE if:
1) Your ISP gave you a user name and password that is required to connect to
the Internet;
2) Your ISP gave you software such as WinPOET, Enternet300 that you use to
connect to the Internet; or,
3) You must double-click on a desktop icon other than your browser to get on
the Internet.
To set the Router to use PPPoE, type in your user name and password in the
spaces provided. If you do not have a service name or do not know it, leave the
“Service Name” field blank. After you have typed in your information, click
“Apply Changes” (6). After you apply the changes, the Internet Status indicator
will read “connection OK” if your Router is set up properly.
1. User Name
This space is provided to type in your user name that was assigned by your ISP.
2. Password
Type in your password and retype it into the “Retype Password” box to confirm it.
3. Service Name
A service name is rarely required by an ISP. If you are not sure if your ISP
requires a service name, leave this blank.
(1)
(2)
(3)
(4)
(5)