Xenyx 1222fx – Behringer XENYX 1222FX User Manual

Page 12

XENYX 1222FX

Connect microphones before you switch on the

phantom power supply. Please do not connect

microphones to the mixer (or the stagebox/

wallbox) while the phantom power supply is

switched on. In addition, the monitor/PA

loudspeakers should be muted before you activate

the phantom power supply. After switching on,

wait approx. one minute to allow for system

stabilization.

Caution! You must never use unbalanced XLR

connectors (PIN 1 and 3 connected) on the MIC

input connectors if you want to use the phantom

power supply.

SERIAL NUMBER

Please note the important information on the serial number

given in chapter 1.3.3.

3. DIGITAL EFFECTS PROCESSOR

AND XPQ SURROUND FUNCTION

3.1 Digital effects processor