Behringer BLUES OVERDRIVE BO100 - Manual

BLUES OVERDRIVE BO100
Thank you for showing your confidence in us by purchasing the BEHRINGER BLUES
OVERDRIVE BO100. This classic effects pedal is specifically designed to deliver the
warm and emotive distortion usually known from 30-year-old classic tube amps. Thanks
to its high-performance features you will achieve the tone of a vintage and bluesy tube
amp that captures every nuance of your playing. And if you feel like it, you can rock out
with full-blast distortion.
1. CONTROLS
Top view
The LEVEL control adjusts the output level.
The TONE control adds tube-like warmth to the overall sound.
Use the GAIN control to adjust the amount of overdrive.
The ON/BATT LED illuminates when the effect is activated. It also serves as a
battery level indicator.
Use the footswitch to activate/deactivate the effect.
Use this 1/4" TS IN connector to plug in the instrument cable.
The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery, press the hinges with a ballpen and remove the pedal cover. Be
careful not to scratch the unit.
+
The BO100 has no on/off switch. As soon as you insert the jack into the
IN connector, the BO100 begins running. When not using the BO100,
remove the jack from the IN connector. This extends the life of the
battery.
The SERIAL NUMBER is located at the bottom.