Beko 15LB250MID - Manual (Page 25)

23
• Temporary sound mute may be on. Try
pressing the mute button.
• Is the sound turned down?
The remote control does not
function
• Try replacing the batteries.
• Make sure that there are no obstructions
between the remote control and
television.
If your television does not work properly
even though you tried the above mentioned
solutions, try turning it on and off again. If
you cannot start your television even though
you have applied all noted methods, refer to
the dealer or authorised service from where
you purchased the product. Never attempt
to repair a faulty device yourself.
Symptoms Solution
Turn on the power on/off switch Turn on another channel, the broadcast may be distorted Check the aerial connection There may be a break in the aerial cable Change the aerial direction There may be a regional problem in the broadcast Fine tuning may be required Brightness setting may be required Contrast setting may be required The channel may not be broadcasting in colors Color adjustment may be required Check the batteries Try powering on and off the TV
No picture and sound √ √ √ √ √
No sound, picture available √ √ √
No picture, sound available √ √ √ √ √ √
Low quality picture √ √ √ √ √
Foggy picture √ √ √ √
Double picture √ √ √ √ √
Line on the picture √ √ √ √ √
Distorted picture √ √ √ √
Distorted broadcast on some channels √ √ √ √ √ √
Horizontal lines exist √ √ √
Vertical fluttering in the picture √ √ √ √
Weak color √ √ √ √ √ √ √ √ √
No color √ √ √ √ √ √ √
The remote control does not function √ √
TV does not respond to the commands √
Fluttering in the teletext √
11 Technical specifications chart
SCREEN SIZE 15”
Panel type
15”, 4:3
Active matrix
TFT
Sound output 2x2 W
Power consumption 22 W
Stand by power value <2 W
Teletext page 8
General technical specifications
Power supply AC: 230V 50 Hz
Power supply DC: 12V (*)
Program memory Analog: 100
Program memory Digital: 1000
RF Aerial input: 75 Ohm (Co-axial)
Loudspeaker impedance: 8 Ohm
Sound systems: Mono / AV Stereo
Batteries: 2xUM - 4, IEC R03 or AAA 1.5V
Channels received: VHF (Band I Channel 2-4)
VHF (Band III Channel 5-12)
UHF (Channel 21-69)
Cable TV (S1-S20/S21-S41)
Broadcasting systems received: PAL BG
PAL SECAM BG
PAL SECAM BG DK
PAL SECAM BG LL’
PAL I
(*): These features are optional and they are not available on all models.
Note: Your television has been manufactured
in accordance with the system available in your
country and this system cannot be changed by
the user.