Beko 15LB250MID - Manual (Page 16)

14
6.3.5.1-Language Settings
You can select subtitle and sound language
provided that the broadcast is supported for
all digital broadcasting channels. Unless you
make a selection, the language supported by
the broadcaster will be selected automatically.
To perform language selection, select
Subtitling Language 1, Subtitling
Language 2, Audio Language 1,
Audio Language 2 tab from the
Language Settings menu by using
Up/Down movement buttons and
make your language selection with
Left/Right movement buttons. You
can also select subtitles directly by
SUBT button on your remote control
or make sound selection by AUDIO
button.
6.3.5.2-Access Control
With this feature, you can lock the channels
that are not suitable for children.
Access Control
Lock/Unlock Channels
Change PIN
Select Back
Lock/Unlock Channels: Select Lock/
Unlock Channels tabs from Access Control
menu and press OK button to confirm. All
TV Channels list will be displayed; select the
channel you want to lock with Up/Down
movement buttons and press OK button
to confirm. x mark will be displayed at the
beginning of the channel which is locked.
To unlock, repeat the same steps. Select
the channel to access the locked channel
and enter the correct password into the
displayed password screen. The channel
will not be displayed unless the correct
password is entered.
Note 1: To re-prevent access after entering
the correct password and displaying the
locked channel, your television has to be
switched to Standby mode and turned on
again.
Note 2: The password has been set as 0000
at the factory. You can change the password
as you wish under Change PIN item in the
Access Control menu.
6.3.5.3-User Interface Options
With this feature, you can decide whether
to display in the list the channels that could
not be unscrambled by the CI card installed
on your television. To do this, you can select
ON, OFF or AUTO options.
6.3.5.4-Timers
In this menu you can view Reminders you
had entered from the EPG or change the
entered Reminders.
6.3.5.5-Favourite Lists
Please see 6.3.3.2-Creating favorite channel
list for detailed explanation of this feature.
6.3.5.6-Common Interface Module
In this menu, you can check the CI Module
settings that you can attach to your
television.
6.3.5.7-System Menu
You can display your television’s hardware
and software data under this menu.
6.4-Performing Analogue
Tunings
You can either tune the programs
automatically or manually and store them in
your television.
6.4.1-Automatic tuning of channels
and storing in the memory
Note: If your television does not receive any
aerial broadcast for a period of 5 minutes,
it automatically switches to the stand-by
position. The countdown symbol is displayed
on the screen during the last 1 minute.
You can tune the programs
automatically with the Autoprogram
function of your television and then
sort the channels as you desire
by means of the Program Table.
Press the MENU button on your
remote control. Select SETUP tab
by pressing the down movement button
and confirm your selection with OK button.
Setup menu is displayed. Select PROGRAM
NO tab by pressing the Up/Down