Baby Trend DOUBLE SNAP N GO 1304TW User Manual

Page 9

Installation Instructions for Cosco

Designer/Opus 35

The Double Snap-N-Go

will accommodate the Cosco

Designer/Opus 35

Infant Car Seat. Please follow these instructions for proper installation of

the Cosco

Front Seat:

1. Remove (unscrew) Crossbars A1, C and D from the

Double Snap-N-Go

frame. Leave Crossbar B1 in hole labeled #4. Remove the Car Seat Straps

from the

Double Snap-N-Go

frame. Retain the screws you remove.

2. Attach Crossbar B1 (removed from the rear section of the

Double Snap-

N-Go

frame), so that the bent section faces down, to the

Double Snap-N-

frame using the two holes labeled #5. Use the two screws that you

removed in step 1. Please see figure 1.

3. Attach both Car Seat Straps to the

Double Snap-N-Go

frame using the

two holes labeled #3. Use the two screws that you removed in step 1.

Please see figure 1.

Rear Seat

1. Remove (unscrew) Crossbars A2 and B1 from the

Double Snap-N-Go

frame. Remove the Car Seat Straps from the

Double Snap-N-Go

frame.

Retain the screws you remove.

2. Attach Crossbar C (removed from the front section of the

Double Snap-N-

frame) to the

Double Snap-N-Go

frame using the two holes labeled

#4. Use the two screws that you removed in step 1. Please see figure 2.

3. Attach both Car Seat Straps to the

Double Snap-N-Go

frame using the

two holes labeled #1. Use the two screws that you removed in step 1.

Please see figure 2.

Insertion of the Cosco

Designer/Opus 35 Infant Car Seat

1. With one hand grasp the car seat handle (in its upright, carrying position)

and with your other hand squeeze the handle on the back of the car seat

and gently place the seat, so that the baby faces the rear, onto the

Double

Snap-N-Go

so that the rear small grooves on the seat bottom hook over

Crossbar B1 for the front position or Crossbar C for the rear position.

Release the handle and check that the seat locked onto the bar. See

Figure 3.

FOR SAFE OPERATION, IT IS VERY IMPORTANT

THAT THE REAR LATCHES OF THE SEAT LOCK SECURELY

ONTO THE CROSSBAR.

2. Feed the Car Seat Straps through the slots found on the rear of the Car

Seat shell as shown in figure 4. Buckle the two straps together. The first

time your do this, you will need to adjust the length of the strap for a tight

fit around the car seat. Please see figure 4.

3. Test for secure installation by moving the car seat in all directions. The

car seat should be securely attached to the

Double Snap-N-Go

Removal of the Cosco

Designer/Opus 35 Infant Car Seat

1. Unlock the Car Seat Strap and remove.

2. With one hand, grasp the car seat handle (in its upright, carrying position)

and with your other hand squeeze the handle on the back of the car and

lift the car seat upward from the

Double Snap-N-Go

. See Figure 5.

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Bar B1

Bar B2

Bar C

Bar B1

down

Hole #3

Hole #4

Hole #5

Hole #4

Hole #3

Hole #1

Strap

Cosco

and Designer/Opus 35

are the trademarks of their owners. They are

not associated with Baby Trend and no approval or endorsement is implied.