Baby Trend DOUBLE SNAP N GO 1304TW - Manual (Page 4)

WARNING:
Do not place hot liquids in the
parent tray. Hot liquids can burn your child. Do not
place more than 3 pounds in the tray as it may cause a
hazardous unstable condition to exist.
Your stroller is now ready to use
BRAKES
WARNING:
Always set brakes when the stroller
is not being pushed so that the stroller will not roll away.
Never leave stroller unattended on a hill or incline as the
stroller may slide down the hill.
• To engage brakes, apply light downward pressure to the brake lever located on
each rear wheel. The stroller may require slight forward or rearward movement
in order to line up the teeth on the brake with the each wheel brake cluster. See
figure 5. Check that the stroller will not move and that the brakes are properly
applied. To release, gently lift up on the brake lever. See figure 6.
TO FOLD STROLLER:
Do Not allow children near stroller while folding.
• The front section of the frame may be folded back to reduce the folded size of
the stroller. To fold the front frame, slide the plastic fittings forward while lifting
upward on the frame. Rotate the front frame backwards to rest on the rear portion
of the frame. Please see figure 7a and 7b.
• Lift upward on the secondary safety lock on the left side of the stroller just above
the rear wheel. Please see figure 8. Lift upward on the spring loaded automatic
latch on the right side of the stroller just above the wheel while pushing forward
on the handle. Please see figure 9. Once the stroller begins to fold, release
the latch and pull upward on the front of the stroller until the stroller is folded.
Please see figure 10. Secure the stroller in the folded position by latching the fold
latch, located on the right side of the stroller handle, over the extended rivet on
the front leg. Please see figure 11.
TO UNFOLD STROLLER:
Do Not allow children near stroller while unfolding.
• Release the folding latch, which is located on the right side. See
figure 11.
• Lift up on the stroller handle with both hands until the stroller frame
is erect and locked in the open position. See figure 10. The stroller
has a spring-loaded latch on the right side of the frame. Test that
latch is fully engaged. Engage the manual secondary safety lock
on the left side of the frame prior to placing your car seats on the
stroller. See figure 8.
• Extend the front frame by rotating it forward. See figure 7b. Check
that the two plastic fittings both latch onto the front upper tube of
the stroller frame. See figure 7a.
Fig. 7a
Fig. 7b
Fig. 8
Fig. 9
Fig. 10
Fig. 11 4