Baby Trend DOUBLE SNAP N GO 1304TW User Manual

Page 11

Installation Instructions for Evenflo

On My Way

The Double Snap-N-Go

will accommodate the Evenflo

On My Way

Infant Car Seat. Please follow the following instructions for proper

installation of the On My Way.
Front Seat:

1. Remove (unscrew) Crossbars A1, C, B1 and D from the

Double Snap-N-

frame. Remove the Car Seat Straps from the Double Snap-N-Go

frame. Retain the screws you remove.

2. Attach Crossbar B1 with sleeve to the

Double Snap-N-Go

frame using

the two holes labled #4 as shown in figure 1. use the two screws that you

removed in step 1.

3. Attach Crossbar C to the

Double Snap-N-Go

frame using the two holes

labeled #6 as shown in figure 1. Use the two screws that you removed in

step 1.

4.Attach the Car Seat Straps to the

Double Snap-N-Go

frame using the two

holes labeled 5 as shown in figure 1. Use the two screws that you removed

in step 1.

Rear Seat:

1. Remove (unscrew) Crossbars A2, B2, and B1 from the

Double Snap-N-

frame. Retain the screws you remove.

2. Attach Crossbar B2, so that the bent section faces down, to the

Double

Snap-N-Go

frame using the two holes labeled #3 as shown in figure 2.

Use the two screws that you removed in step 1.

Insertion of the Evenflo

On My Way Infant Car Seat

1. With one hand grasp the car seat handle (in its upright, carrying position)

and gently place the seat, so that the baby faces the rear of the

Double

Snap-N-Go

, onto the

Double Snap-N-Go

so that the large groove on

the seat bottom, nearest the head-end of the seat, hooks over Crossbar

C in the front or crossbar B2 in the rear. Check that the seat locked onto

the Crossbar. See Figure 3.

FOR SAFE OPERATION, IT IS VERY

IMPORTANT THAT THE SEAT LOCK SECURELY ONTO THE

CROSSBAR.

2. Feed the Car Seat Straps through the auto belt slots on the infant car seat as

shown in Figure 4 and snap the two buckles together. The first time your

do this, you will need to adjust the length of the strap for a tight fit around

the car seat.

FOR SAFE OPERATION, IT IS VERY IMPORTANT

THAT THE CAR SEAT STRAP IS ALWAYS TIGHTLY FASTENED

OVER THE CAR SEAT.

3. Test for secure installation by moving the car seat in all directions. The

car seat should be securely attached to the

Double Snap-N-Go

Removal of the Evenflo

On My Way Infant Car Seat

1. Unlock the Car Seat Strap and remove from over the infant car seat.

2. With one hand, grasp the car seat handle (in its upright, carrying position)

and with your other hand squeeze the red handle on the back of the car

seat and lift the car seat upward from the

Double Snap-N-Go

frame. See

Figure 5.

Bar B1
Sleeve

Hole #6

Hole #5

Hole #4

Strap

Bar B2

down

Hole #3

Hole #5

Strap

Bar C

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Evenflo

and On My Way

are the trademarks of their owners. They are not

associated with Baby Trend and no approval or endorsement is implied.