Black Box LR5100A-T - Manual (Page 16)

Applications
8
Setting the T1/E1Parameters
(T1/E1 WAN only)
The parameters required for a T1 or E1 connection may be obtained from your service
provider. These may then be entered via the T1/E1 set-up menu to configure the router for
that service.
T1/E1 Selection:
Location: Main
Ä Configuration
Ä WAN Set Up
Ä Link Set Up
Ä T1/E1 Set Up
Ä Link mode
T1 or E1
Set the service mode to which this router will be connected.
Service parameters:
Location: Main
Ä Configuration
Ä WAN Set Up
Ä Link Set Up
Ä T1/E1 Set Up
Ä Speed/Channel rate
56/64 kbps
Ä T1/E1framing
framed/unframed/SF/ESF
Ä Line encoding
AMI/INV_AMI/
B8ZS/HDB3
Select the service channel speed, framing format, and encoding as designated by the
service provider.
T1 service requires the specification of a Line Build Out factor. This parameter modifies the
transmitted signal to compensate for degradation due to line losses between the transmitter
and receiver. A number of different options are available to meet standards for T1 long haul
(direct connection to service providers central office facility), T1 short haul (connection
through a local PBX), AT&T TR64211 specification long haul and AT&T TR64211 short
haul. Your service provider will tell you which specification their service requires. Short haul
LBOs are listed as the length of the cable run (in feet) between the router and the local
exchange.
7
7