Cleaning the appliance, Interior fittings, Take out glass shelves – Neff K4316X7GB User Manual
Page 11: Taking out pull-out container, Condensation channel, Taking out vegetable container with cover, Take out shelves in the door, Taking out the bottle holder, Ventilation opening, En 11
en
11
Cleaning the appliance
m
Caution
■
Do not use abrasive, chloride or acidic
cleaning agents or solvents.
■
Do not use scouring or abrasive
sponges. The metallic surfaces could
corrode.
■
Never clean shelves and containers
in the dishwasher. The parts may
become deformed!
Proceed as follows:
1. Before cleaning: Switch off the
appliance.
2. Pull out the mains plug or switch off
the fuse!
3. Take out the food and store in a cool
location.
4. Wait until the layer of frost has thawed.
5. Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing-up liquid. The rinsing water
must not run into the light.
6. Wipe the door seal with clear water
only and then wipe dry thoroughly.
7. Rinsing water must not run through
the drainage hole into the evaporation
area.
8. After cleaning reconnect and switch
the appliance back on.
9. Put the food back into the appliance.
Interior fittings
All variable parts of the appliance can be
taken out for cleaning.
Take out glass shelves
Fig. $
Lift the glass shelves, pull forwards,
lower and swivel out to the side.
Taking out pull-out container
Fig. '
Lift the container and pull out.
Condensation channel
Fig. *
To clean the condensation channel, take
out the pull-out container. Fig. !/4
Regularly clean the condensation
channel and drainage hole with a cotton
bud or similar implement to ensure that
the condensation can drain.
Taking out vegetable container with
cover
Fig. (
Lift vegetable container and take out
forwards.
Take out shelves in the door
Fig. &
Lift shelves upwards and take out.
Taking out the bottle holder
Fig. )
Lift bottle holder at the rear and remove
from the door shelf.
Ventilation opening
Fig. +
The ventilation grille in the base can be
removed for cleaning. To do this,
depress the clips in the ventilation
openings and simultaneously remove
the ventilation grille forwards.