Billion Electric Company BiPAC 7300GX - Manual (Page 13)

12
2.4 The Rear Ports
Port Description
1
Power
Switch
Power ON/OFF switch.
2 Power Connect the supplied power adapter to this jack.
3
3G card
slot
Connect the 3G card bus data card to this slot
4 Reset
After the router is powered on, press this reset button using the
end of paper clip or other small pointed object to reset the router
and to restore it to factory default settings.
1. Recovery procedures for non-working routers (e.g. after a
failed firmware upgrade flash).
2. Recovery procedures for a lost web interface password:
5 WPS Push WPS button to trigger Wi-Fi Protected Setup function.
6
Ethernet
Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one of the
four LAN ports when connecting to a PC or an office/home
network of 10Mbps or 100Mbps.
7 DSL
Connect the supplied RJ-11 (“telephone”) cable to this port when
connecting to the ADSL/telephone network.
8 Antenna Connect the detachable antenna to this port.
3
2
4 1
8
7 6
5
Attention
The 3G card slot does not support hot swap (swapping whilst the
device is still turned on). If you need to change the 3G card, please
turn the power off before replacing the 3G card.
Attention