BenQ SP870 - Manual (Page 47)

47 Maintenance
6. As shown in the figure, hold the new lamp and
align the two locators on the lamp with the holes
on the projector, and then insert the lamp all the
way into the projector.
7. Tighten the screw that secures the lamp.
Loose screw may cause a bad connection,
which could result in malfunction.
Do not over tighten the screw.
8. Ensure the handle is fully laid flat and locked in
place.
9. Replace the lamp cover on the projector.
10. Tighten the screw that secures the lamp cover.
Loose screw may cause a bad connection,
which could result in malfunction.
Do not over tighten the screw.
11. Restart the projector.
Do not turn the power on with the lamp cover
removed.
Resetting the lamp timer
12. After the startup logo, open the On-Screen
Display (OSD) menu.
Go to the SYSTEM SETUP: Advanced > Lamp
Settings menu.
Press ENTER and the Lamp Settings page
displays.
Highlight Reset Lamp Timer. A warning message
displays asking if you want to reset the lamp
timer.
Highlight Reset and press ENTER on the
projector or remote control. The lamp time will
be reset to '0'.
Do not reset if the lamp is not new or replaced
as this could cause damage.
Reset Lamp Timer?
Reset Cancel
Notice