Bloomfield 8752 - Manual (Page 8)

OPERATION
Fig. 4 Brewer Operation Diagram
START-UP
For initial start-up, or if the brewer has not been used for an
extended period of time:
♦ Be sure spray disk and brew gasket are properly installed in the
brew head.
♦ Be sure the water supply is properly connected and the water
supply valve is turned ON.
♦ Be sure the WATER TANK IS FILLED
BEFORE connecting brewer to electrical power THE WATER TANK
MUST BE FILLED. Place an empty decanter under the brew head.
Lift the pour-over cover then pour warm tap water into the pour-over
opening until water flows from the brew head. When water stops
dripping from the brew head, empty the container.
Once the tank is full of water, connect the brewer to electrical
power. Press the TANK HEATER SWITCH to “
ON ”. The heating
elements will begin heating the water in the tank. When the water
has reached the proper temperature, the READY TO BREW light
will glow.
IMPORTANT:
Tank must be full of water
before pressing TANK
HEATER SWITCH "
ON ".
Heating elements will be
damaged if allowed to
operate without being
fully submerged in water.
Damage caused by
operating the brewer
without water in the tank
is NOT COVERED BY
WARRANTY.
6
605
70
988
Ow
ners
M
a
nual
Integri
ty
5
W
D
e
can
te
r B
rew
er