Nokia N90 - Manual (Page 89)

Co
n
n
ec
ti
vit
y
80
4 If the other device requires pairing before data can be
transmitted, a tone sounds, and you are asked to enter
a passcode. See “Pair devices‚" p. 80.
5 When the connection has been established, Sending
data is shown.
The Sent folder in Messaging does not store messages sent
using a Bluetooth connection.
Tip! When searching for devices, some devices may
show only the unique addresses (device addresses).
To find the unique address of your phone, enter the
code *#2820# in the standby mode.
Pair devices
Glossary: Pairing means authentication. The users of
the two devices with Bluetooth technology should
agree on a common passcode, and use the same
passcode for both devices in order to pair them.
Devices that do not have a user interface have a
factory-set passcode.
In the Bluetooth main view, press to open the paired
devices view ( ).
Before pairing, create your own passcode (1—16 digits),
and agree with the owner of the other device to use the
same code. The passcode is used only once.
To pair with a device, select Options > New paired device .
Devices with Bluetooth technology that are within range
start to appear on the display one by one. Select the device,
and enter the passcode. The same passcode must be entered
on the other device as well. After pairing, the device is
saved to the paired devices view.
Paired devices are indicated by in the device search.
Tip! To define a short name (nickname or alias) for
a paired device, scroll to the device, and select
Options > Assign short name in the paired devices
view. This name helps you to recognize a certain
device during device search or when a device
requests a connection.
To set a device to be authorized or unauthorized, scroll to
a device, and select from the following options:
Set as authorized —Connections between your device and
this device can be made without your knowledge. No separate
acceptance or authorization is needed. Use this status for
your own devices, such as your compatible headset or PC,
or devices that belong to someone you trust.
indicates
authorized devices in the paired devices view.
Set as unauthorized —Connection requests from this
device must be accepted separately every time.
To cancel a pairing, scroll to the device, and select Options >
Delete . If you want to cancel all pairings, select Options >
Delete all .
Tip! If you are currently connected to a device and
delete the pairing with that device, pairing is removed
immediately and the connection will be switched off.