Brother XC6771-021 - Manual (Page 38)

SEWING BUTTONHOLES AND BUTTONS ————————————————————————————————————————————
36
Sewing Buttons
1
Measure the distance between the
buttonholes and set the pattern selection dial
to the Zigzag Stitch, and set the width you
want.
2
Remove the power supply plug from the
outlet.
3
Change the foot to the button sewing foot.
4
Place the darning plate on the needle plate.
5
Connect the power supply plug into the wall
outlet.
6
Put a button between the foot and the fabric
and make sure that the needle enters the holes
without hitting the button. If it hits, see step
1
.
7
At a slow speed, sew about 10 stitches.
8
Remove the material from the machine. Cut
the upper and lower threads and tie both
threads at the back of the material.
Stitch
Name Pattern
Stitch
Length
[mm (inch)]
Stitch
Width
[mm (inch)]
Foot Other
Zigzag
Stitch
F
(1/64)
Any
Button
Sewing
Foot
Darning
Plate
● Make sure the needle does not hit the
button during sewing. The needle may
break and you may be injured.
CAUTION
XL2600.book Page 36 Thursday, November 4, 2004 9:46 PM