Nokia 2760 - Manual (Page 7)

7
General information
■ Access codes
The security code supplied with the phone protects your phone against unauthorized use.
The preset code is 12345.
The PIN code, supplied with the SIM card, protects the card against unauthorized use.
The PIN2 code, supplied with some SIM cards, is required to access certain services. If you
enter the PIN or PIN2 code incorrectly, three times in succession, you are asked for the PUK
or PUK2 code. If you do not have them, contact your local service provider.
The module PIN is required to access the information in the security module of your SIM card.
The signing PIN may be required for the digital signature. The restriction password is required
when using the call restriction service.
Select Menu > Settings > Security to set how your phone uses the access codes and
security settings.
1. Get started
■ Install the SIM card and battery
Always switch the device off and disconnect the charger before removing the battery.
For availability and information on using SIM card services, contact your SIM card vendor.
This may be the service provider or other vendor.
This phone is intended for use with a BL-4B battery.
Note: Always switch off the power and disconnect the charger and any other device
before removing the cover. Avoid touching electronic components while changing
the cover. Always store and use the device with the cover attached.
To install the SIM card:
1. Press and slide the back cover toward the top of the phone to remove it.
2760.EN_ESv1_BIL_9203985.book Page 7 Tuesday, September 18, 2007 11:11 PM