beautypg.com

Get started, Install smartchip card and battery, Charge the battery – Nokia 6126 User Manual

Page 43

background image

10

1. Get started

Install SmartChip card and battery

Always switch the device off and disconnect the charger before removing the battery.

Keep all SmartChip cards out of the reach of small children.

For availability and information on using SmartChip card services, contact your SmartChip
card vendor. This may be the service provider or other vendor.

This device is intended for use with BL-4C battery. Always use original Nokia batteries.
See ”Nokia battery authentication guidelines,” p. 61.

The SmartChip card and its contacts can easily be damaged by scratches or bending, so be
careful when handling, inserting, or removing the card.

To install the SmartChip card:

1. Press slightly to remove the

back cover of the phone.

2. Slide the cover off.

3. Remove the battery, as shown.

4. Open the SmartChip card holder.

5. Insert the SmartChip card

properly into the holder.

6. Close the SmartChip card holder.

7. Replace the battery.

8. Replace the back cover.

9. Slide the back cover until it

locks into place.

Charge the battery

Check the model number of any charger before use with this device. This device is intended
for use when supplied with power from an AC-3 or AC-4 charger.

Warning: Use only batteries, chargers, and enhancements approved by Nokia for
use with this particular model. The use of any other types may invalidate any
approval or warranty, and may be dangerous.