Installing your tv, Safety precautions, Air circulation heat damage mains supply do – Toshiba W4333 User Manual
Page 4: Do not
4
En
g
lis
h
INSTALLING YOUR TV
Safety Precautions
This equipment has been designed and manufactured to
meet international safety standards but, like any electrical
equipment, care must be taken to obtain the best results
and for safety to be assured. Please read the points below
for your own safety. They are of a general nature, intended
to help with all electronic consumer products, and some
points may not apply to the goods you have just
purchased.
Leave more than 10 cm clearance around the television to
allow adequate ventilation. This will prevent overheating
and possible damage to the television. Dusty places
should also be avoided. For wall mounted positions at
least 2.5 cm gap was retained from the wall and the 10 cm
was kept clear around all edges of the TV.
Damage may occur if the television is left in direct sunlight
or near a heater. Avoid places subject to extremely high
temperatures or humidity. Place in a location where the
temperature remains between 5 °C min. and 35 °C max.
The mains supply required for this equipment is 220-240 V
AC 50 Hz. Never connect to a DC supply or any other
power source. DO ensure that the television is not
standing on the mains lead.
DO NOT cut off the mains plug from this equipment, this
incorporates a special Radio Interference Filter, the
removal of which will impair its performance.
In the UK, the fuse fitted in the plug is approved by ASTA
or BSI to BS1362. It should only be replaced by a correctly
rated and approved type and the fuse cover must be
refitted.
IF IN DOUBT, PLEASE CONSULT A COMPETENT
ELECTRICIAN.
DO
read the operating instructions before you attempt to
use the equipment.
DO
ensure that all electrical connections (including the
mains plug, extension leads and inter-connections
between pieces of equipment) are properly made and in
accordance with the manufacturers’ instructions. Switch
off and withdraw the mains plug before making or
changing connections.
DO
consult your dealer if you are ever in doubt about the
installation, operation or safety of your equipment.
WARNING:
To prevent injury, this apparatus must be
securely attached to the floor/wall in accordance with the
installation instructions. See page 5.
DO
be careful with glass panels or stands on equipment.
DO
use a soft, dry cloth to clean the unit.
DO NOT
obstruct the ventilation openings of the
equipment with items such as newspapers, tablecloths,
curtains, etc. Overheating will cause damage and shorten
the life of the equipment.
DO NOT
allow electrical equipment to be exposed to
dripping or splashing or objects filled with liquids, such as
vases, to be placed on the equipment.
DO NOT
place hot objects or naked flame sources, such
as lighted candles or nightlights on, or close to equipment.
High temperatures can melt plastic and lead to fires.
DO NOT
use makeshift stands and NEVER fix legs with
wood screws.
DO NOT
leave equipment switched on when it is
unattended, unless it is specifically stated that it is
designed for unattended operation or has a standby
mode. Switch off by withdrawing the plug, and make sure
your family knows how to do this. Special arrangements
may need to be made for people with disabilities.
DO NOT
continue to operate the equipment if you are in
any doubt about it working normally, or it is damaged in
any way – switch off, withdraw the mains plug and consult
your dealer.
DO NOT
push/pull CI CAM at a tilt to prevent breakdown
of COMMON INTERFACE.
WARNING:
Excessive sound pressure from earphones
or headphones can cause hearing loss.
ABOVE ALL - NEVER let anyone, especially
children, push or hit the screen and cabinet
back, or push anything into holes, slots or any
other openings in the case. These actions will
damage screen or internal parts.
NEVER guess or take chances with electrical
equipment of any kind - it is better to be safe
than sorry.
Air Circulation
Heat Damage
Mains Supply
Do
DO NOT REMOVE ANY FIXED COVERS AS THIS
WILL EXPOSE DANGEROUS AND ‘LIVE’ PARTS.
THE MAINS PLUG IS USED AS THE
DISCONNECTING DEVICE AND THEREFORE
SHOULD BE READILY OPERABLE.
Do not
WARNING:
To prevent the spread of
fire, keep candles or other open flames
away from this product at all times.