beautypg.com

Toshiba DVR20 User Manual

Page 74

background image

74

EN

Symptom

Remedy

CHANNEL

TV channels cannot be changed.

• Check if the connections are made securely and correctly.
• Check if the cables are damaged.
• Try “Channel” setting by following the steps on pages 20-22.

Some settings are lost even though you
followed the procedure correctly.

• If you unplug the AC mains cable while the warning message, “Saving settings.

Please wait.”, is displayed, some settings may be lost. Do not unplug the AC
mains cable while the message is displayed (It will take about 1 minute.).

Only specific channels do not appear.

• The channels may be set to be skipped. (See pages 22, 24.)

Though auto tuning was completed,
you cannot watch the DVB and
analogue channels.

• Confirm whether an antenna cable is connected correctly and try to tune again.

(See pages 20-26.)

• If you move the unit to a different area, you will need to perform auto tuning

again.

The TV channel which you have been
able to watch before has disappeared
and “No signal” is displayed.

RE

CORDING

GENERAL

The image from the external device
cannot be displayed.

• Try pressing [INPUT SELECT

F] repeatedly to select the external input

channel, then press [PROG.

G \ H] repeatedly to select your desired

channel.

• Turn on all connected devices.
• Check if the connections are made securely and correctly.

DV

D

Recording is impossible.

• This unit cannot record programmes that contain copy protection signal. This is

not a malfunction.

• The space of the recording media may be used up. Try deleting unnecessary

titles, or exchange it with the recordable media.

• The maximum number of titles or chapters has exceeded. Delete the

unnecessary titles to make enough space or insert a new recordable media.

• Check if the disc is CPRM compatible. Copy-once programmes can only be

copied onto the disc which is CPRM compatible.

• Check if the disc is protected or finalised. Undo the protection or the finalisation.
• DVD-RW once formatted in other unit cannot be recorded in this unit unless

formatted in this unit.

• Check if the connections are made securely and correctly.

Timer recording cannot be
performed.

• The internal clock of the unit may have been stopped due to a power failure that

lasted for more than 30 seconds. Reset the clock. (See page 67.)

“Repairing” appears on the TV
screen.

• If there is a power failure or unplugging during recording, finalising, formatting or

editing (even after “Repairing” disappears), a repairing process will begin
automatically just after turning the unit on again.

• It may take several minutes up to about several hours.

In a case you intend to cancel the
repairing process.

• If you intend to cancel the repairing process, press [A OPEN

\CLOSE] on the

front panel, then select “Yes” and press [ENTER

\OK]. After that, press

[OPEN

\CLOSE A] to take out the disc. The disc cancelled during the repairing

process MAY NOT work.

The indication

does not disappear.

• “

” may remain on screen for the maximum of

20 seconds even after it reached 100%. This is not a malfunction.

VCR

Recording does not start
immediately after pressing
[REC I].

• Make sure the videotape has a recorded tab when you record to a videotape. If

needed, cover the hole with cellophane tape.

Repairing

Do you want to cancel a repairing

process? When selecting “Yes”,

the disc may not be usable.

No

Yes

Repairing

100%

Writing to Disc

100%

Writing to Disc

E9TK4BD_EN.book Page 74 Wednesday, January 6, 2010 10:05 PM