Installing batteries in the remote control, Switching dvd / vcr mode, About the remote control – Toshiba DVR20 User Manual

Page 12

Installing Batteries in the Remote

Control

Install 2 R6 (1.5 V) batteries (supplied) into the remote
control, carefully match with the polarity indicated inside the
battery compartment.

Caution

• Incorrect use of batteries can result in hazards such as

leakage and bursting.

• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
• Make sure that the plus (+) and minus (–) ends of each

battery match the indications inside the battery
compartment.

• Remove batteries if the equipment will not be used for a

month or more.

• When disposing used batteries, please comply with

governmental regulations or the public instructions for
environmental protection that apply in your country or area.

• Do not recharge, short-circuit, heat, burn or disassemble

batteries.

• Make sure there is no obstacle between the remote control

and the remote control sensor on the unit.

• Use within the operating range and angle as shown.

• The maximum operable range as follows:

• Remote control operation may become unreliable if the

remote control sensor of the unit is being exposed by the
strong sunlight or fluorescent light.

• Remote controls for different devices can interfere with each

other. Be careful when using remote controls for other
equipment located close to the unit.

• Replace the batteries when the operating range of the

remote control reduces.

Switching DVD / VCR mode

You must select which component you want to operate first.
Press [DVD] or [VCR] on the remote control or the front
panel.

Press [DVD] on the remote control.

Press [VCR] on the remote control.

Note

• You can also press [SELECT] on the front panel to switch

between DVD and VCR mode.

About the Remote Control

Line of sight:

approximately 7 m

Either side of centre: approximately 7 m within 30 degrees

VCR

DVD

Within
about 7 m

7 m (30°)

7 m

7 m (30°)

DVD

VCR

VCR

DVD

PROGRAM

DUBBING

SELECT

DVD

VCR

USB

DV IN

SELECT

DVD

VCR

Device select indicators

indicator

DVD button

VCR button

button

E9TK4BD_EN.book Page 12 Wednesday, January 6, 2010 10:05 PM