Toshiba Tecra A6 (PTA60E) - Manual (Page 65)

User’s Manual 4-7
Operating Basics
Disconnecting the LAN cable
To disconnect the LAN cable, follow the steps below.
1. Pinch the lever on the connector in the computer's LAN jack and pull
out the connector.
2. Disconnect the cable from the LAN hub in the same manner. Check with
your LAN administrator before disconnecting from the hub.
Wireless LAN
The wireless LAN is compatible with other LAN systems that comply with
the IEEE 802.11a/b/g wireless LAN standards.
It supports the following:
■ Automatic Transmit Rate Select mechanism in the transmit range of
54, 11, 5.5, 2 and 1 Mbit/s.
■ Advanced Encryption Standard (AES) data encryption, based on 128bit
encryption algorithm. (Revision G combo type.)
■ Frequency Channel Selection (2.4 GHz or 5 GHz)
■ Roaming over multiple channels
■ Card Power Management
■ Wired Equivalent Privacy (WEP) data encryption
Wireless LAN disclaimer
The transmission speed over the wireless LAN and the distance over which
wireless LAN can reach may vary depending on surrounding
electromagnetic environment, obstacles, access point design and
configuration, and client design and software/hardware configurations. The
actual transmission speed will be lower than the theoretical maximum
speed.
Security
1. TOSHIBA strongly recommends that you enable the WEP encryption
function otherwise your computer could be left open to illicit access via
the wireless LAN connection which may result in an intrusion that can
lead to the theft or loss of stored data among other things. In addition,
the owner of an Internet connection is responsible for all browsing,
downloading, and uploading activities on that connection. Therefore, an
unsecured wireless network connected directly to the Internet is an
open invitation for outsiders to abuse your ISP account and privileges.
2. TOSHIBA is not liable for the eavesdropping on your data due to the
use of the wireless LAN connection and any damage that may occur
thereof.
Wake-up on LAN does not function on a Wireless LAN.