Toshiba Satellite Pro S750 User Manual
Page 149
User’s Manual
7-4
HW Setup
CPU
This function allows you to set the processor's operating mode.
Dynamic CPU Frequency Mode
This option allows you to configure the power saving modes associated
with the processor - the following settings are available:
LAN
Wake-up on LAN
This feature lets the computer's power be turned on from shudown when it
receives a wake-up packet (Magic packet) from the LAN.
Power will be automatically turned on when a signal is received from an
administrator's computer which is connected via a network.
The following settings can be changed when the Built-in LAN is Enabled.
Connect the AC adaptor when using the Wake-up on LAN function. The
battery retention time will be shorter than the times listed in this manual
when this function is enabled. Refer to the section in chapter 6,
.
Enabled
Enables the Wake-up on Keyboard function.
Disabled
Disables the Wake-up on Keyboard function (Default).
Dynamically
Switchable
The processor's automatic clock speed switching
function is enabled - in use the processor's
operation is automatically switched when
necessary (default).
Always High
The processor's automatic clock speed switching
function is disabled - in use the processor will
always run at its highest level of power
consumption and its highest speed.
Always Low
The processor's automatic clock speed switching
function is disabled - in use the processor will
always run at a lower level of power consumption
and a low speed.
Do not install or remove a memory module while Wake-up on LAN is
enabled.
■
The Wake-up on LAN function consumes power even when the system
is off. Leave the AC adaptor connected while using this feature.
■
Regarding Wake-up on LAN from sleep or hibernation, you must check
the "Allow the device to wake the computer" check box within the LAN
Device properties. (This feature does not effect the Wake-up on LAN
from sleep or hibernation.)