beautypg.com

Toshiba Satellite Pro A120 (PSAC0) User Manual

Page 137

background image

User’s Manual

8-9

Optional Devices

Removing a memory module

To remove the memory module, make sure the computer is in boot mode

then:
1. Set the computer to boot mode and turn the computer’s power off.

Make sure the Power indicator is off.

2. Remove AC adaptor and all cables connected to the computer.
3. Turn the computer upside down and remove the battery pack. Refer to

Replacing the battery pack

section in Chapter 6,

Power and Power-Up

Modes

, for details.

4. Loosen the screw securing the memory module cover. The screw is

attached to the cover to prevent it from being lost.

5. Insert your fingernail or a thin and flat object into the slit and lift it off.
6. Push the latches to the outside to release the module. A spring will

force one end of the module up.

7. Grasp the module by the sides and pull it out.

Figure 8-8 Removing the memory module

8. Seat the memory module cover and secure it with one screw.

9. Install the battery pack. Refer to

Replacing the battery pack

section in

Chapter 6,

Power and Power-Up Modes

, for details.

10. Turn your computer over.

If you use the computer for a long time, the memory modules and the

circuits located close to the memory modules will become hot. In this

case, let them cool to room temperature before you replace them.

Do not touch the connectors on the memory module or on the

computer. Debris on the connectors may cause memory access

problems.

Latches

Be sure that the cover is closed firmly.

This manual is related to the following products: