Bogen WV100 - Manual (Page 4)

Panel Descriptions
Wall-Mount Power Vector Front Panel
1 . Input Volume Control
Each of the 8 module bays are controlled by an independent volume control.
2. Signal / Clip Indicator
A single two-color LED located above each channel’s volume control indicates the audio activity of that chan-
nel’s input. Green indicates signal active at the input; red indicates clipping of the input signal.
3. Panel Input Connector
A combination XLR female and 1/4" stereo phone jack connector provides a panel-mounted input. Parts includ-
ed, but comes uninstalled.
4. Output Limiter Control with Indicator
Control determines maximum amp output level before limiting takes place. Indicator illuminates when limiting
takes place.
5.Average / Peak Switch
This switch determines whether the LED Output Meter registers the average or peak level of the amplifier’s
output.
6. LED Output Level Meter
An 11-segment LED output level meter monitors the output level of the power amplifier.
7.Tape Out
RCA unbalanced signal level output post bass, treble, and master controls.
8. Bass Control
Controls the amount of cut or boost of bass frequencies below 100 Hz.
9.Treble Control
Controls the amount of cut or boost of treble frequencies above 10 kHz.
1 0. Master Volume Control
Controls overall level of mixed input signals.
11 . Power Switch
Controls AC power to the amplifier. Illuminates when ON.
1 2
3
PUSH
2