Switching the auxiliary setting 45, Setting the rear output and subwoofer, Controller – Pioneer AVH-P5900DVD User Manual

Page 45: Setting the fm tuning step 45, Switching the, Operating this unit, Switching the auxiliary setting, Setting the rear output and subwoofer controller, Setting the fm tuning step

Switching the auxiliary setting

Auxiliary equipments connected to this unit
can be activated individually. Set each AUX
source to ON when using. About connecting
or using auxiliary equipments, refer to Using
the AUX source on page 53.

Switching the auxiliary 1 setting

% Touch AUX1 on the initial menu to se-
lect desired setting.

! VIDEO – an iPod with video capabilities

connected with 4-pole mini plug cable (e.g.,
CD-V150M)

! AUDIO – auxiliary equipment connected

with stereo mini plug cable

! OFF – No auxiliary equipment is connected

Switching the auxiliary 2 setting

% Touch AUX2 on the initial menu to turn
auxiliary 2 setting on.

# To turn auxiliary 2 setting off, touch AUX2
again.

Setting the rear output and
subwoofer controller

This unit

’s rear output (rear speaker leads out-

put and RCA rear output) can be used for full-
range speaker (

FULL) or subwoofer (S.W) con-

nection. If you switch the rear output setting
to

S.W, you can connect a rear speaker lead

directly to a subwoofer without using an auxili-
ary amp.
! When the multi-channel processor (e.g.,

DEQ-P6600) is connected to this unit, you
cannot operate this function.

Touch REAR SP on the initial menu.

Touch c or d to switch the rear output

setting.
Touch c to select full-range speaker and FULL
appears in the display. Touch d to select sub-
woofer and

S.W appears in the display.

# When no subwoofer is connected to the rear
output, select

FULL.

# When a subwoofer is connected to the rear
output, set for subwoofer

S.W.

Notes

! Even if you change this setting, there is no

output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
38).

! If you change this setting, subwoofer output

in the audio menu return to the factory set-
tings.

! Both rear speaker leads outputs and RCA rear

output are switched simultaneously in this
setting.

Setting the FM tuning step

Normally the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.

% Touch FM STEP on the initial menu to
select the FM tuning step.
Touching

FM STEP will switch the FM tuning

step between 50 kHz and 100 kHz. The se-
lected FM tuning step will appear in the dis-
play.

Note

The tuning step remains at 50 kHz during manual
tuning.

Operating this unit

Section

Operating

this

unit