Pioneer SC-1223-S - Manual (Page 71)

71
09
Using other functions
2 Use i/j to check the system setting.
The information on the main unit display switches as shown below each time one of the buttons is pressed.
Audio format
f Sampling frequency f MCACC memory f Auto phase control plus correction value f
Input source to be played in ZONE 2 f Input source to be played in the HDZONE f HDMI output setting f
Subzone to which the HDZONE is output
! For some settings, some items are not displayed.
3 When you’re finished, press STATUS again to switch off the display.
Resetting the system
Use this procedure to reset all the receiver’s settings to the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to MULTI ZONE OFF.
! Disconnect the iPod and USB memory device from the receiver beforehand.
! Set the Control with HDMI to OFF (see
HDMI Setup on page 61 ).
1 Switch the receiver into standby.
2 While holding down ENTER on the front panel, press u STANDBY/ON.
The display shows RESET c NO d.
3 Select ‘RESET’ using PRESET k/l, then press ENTER on the front panel.
The display shows RESET? OK.
4 Press ENTER to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory default settings.
! Note that all settings will be saved, even if the receiver is unplugged.
Default system settings
Setting Default
Digital Video Converter ON
SPEAKERS SB/FH ON
Speaker System Normal(SB/FH)
Speaker Setting
Front SMALL
Center SMALL
FH/FW SMALL
Surr SMALL
SB SMALLx2
SW YES
Surround Position IN REAR
Crossover 80Hz
X-Curve OFF
DIMMER Medium bright
Inputs
See
Input function default and possible settings on page 39 .
Input Volume Absorber All Inputs 0dB
HDMI
HDMI Audio
AMP
Control OFF
Setting Default
Control Mode --- (OFF)
ARC (Audio Return Channel) --- (OFF)
PQLS --- (AUTO)
Standby Through OFF
DSP
Power On Level
LAST
Volume Limit OFF
Mute Level FULL
Phase Control ON
Auto Sound Retriever
iPod/USB, INTERNET RADIO, MEDIA
SERVER, FAVORITES, ADAPTER PORT
input function
ON
Other input functions OFF
Sound Delay 0 ms
Dual Mono CH1
DRC AUTO
LFE Attenuate 0dB
Auto delay OFF
Digital Safety OFF
Effect Level ALC (Auto Level Control) 50
2 PL II Music Options
Center Width 3
Dimension 0
Panorama OFF
Neo:X Options Center Gain
Neo:X CINEMA: 1.0
Neo:X MUSIC: 0.3
Neo:X GAME: 1.0
2 PL IIz Options Height Gain MID
All Inputs
Listening Mode (2 ch/multi ch) AUTO SURROUND
Listening Mode (Headphones) STEREO
See also Setting the Audio options on page 65 for other default DSP settings.
MCACC
MCACC Position Memory
M1. MEMORY 1
Channel Level (M1 to M6) 0.0 dB
Speaker Distance (M1 to M6) 3.00 m
Standing Wave (M1 to M6)
ATT of all channels/filters 0.0 dB
SWch Wide Trim 0.0 dB
EQ Data (M1 to M6)
All channels/bands 0.0 dB
EQ Wide Trim 0.0 dB
Network
Network Standby
OFF
DHCP ON