Pioneer VSX-D510 - Manual (Page 30)

30
En
Direct Function (MULTI
CONTROL)
The direct function is a useful feature which allows you
keep the receiver in one function (for example,
controlling your CD player) while putting the remote
control in a different function. This could let you, for
example, use the remote control to set up and listen to a
CD on the receiver and then use the remote control to
rewind a tape in your VCR while you continue to listen
to your CD player.
When the DIRECT function is ON any
MULTI
CONTROL button you press will change the function of
both the receiver and the remote control. When you
turn a DIRECT function OFF, you can operate the
remote control without affecting the receiver. Thus you
could switch the remote control to the VCR and operate
that component while the receiver plays a different
component.
1 To turn the DIRECT function OFF (the
default setting is ON), press REMOTE SET
UP and number button 3 at the same time.
2 To turn the DIRECT function ON (if you
have turned it off), press REMOTE SET UP
and number button 2 at the same time.
TV CONT doesn’t have this feature and thus can’t use
the DIRECT FUNCTION.
Controlling the Rest of Your System
Clearing All the Remote
Control Settings
Clears all presets and restores factory default settings.
1 Press and hold REMOTE SETUP and 0 at the
same time for more 3 seconds.
The LED display at the top of the remote control will
blink. After blinking three times, all the settings will
be cancelled.
MEMO
• When operating a PIONEER DVD/LD player, set the
manufacturer code to “ 111 ” in the preset mode.
• All codes enrolled in the manufacturer code list can
be set even if a code is not displayed.
• TUNER cannot be preset.
• If no commands are entered the receiver
automatically exits the preset code mode after 20
seconds.