Lfe attenuator setting mode, Low cut filter on/off setting mode, Front speakers distance setting mode – Pioneer VSX-D510 User Manual
Page 15: Center speaker distance setting mode, Preparations
15
En
MEMO:
• The initial setting is “
100 Hz
”.
• If all speakers (front, center, and surround) are set to
“Large” in SPEAKERS setting mode, the crossover
frequency cannot be set because there are no “Small”
speakers (
***
appears in the display).
LFE attenuator setting mode
Dolby Digital and DTS audio sources include ultra-low
bass tones. Set the LFE attenuator as needed to prevent
the ultra-low bass tones from distorting the sound from
the speakers.
Press
% or fi to set the attenuation level (0
dB, 10 dB or
**
dB(
∞
)).
10 dB
0 dB
∞
(display "
**
")
MEMO:
• The initial setting is “
0 dB
”.
• When
∞
is selected (
**
appears in the display), LFE
is not available.
Low cut filter ON/OFF setting mode
Turn the low cut filter
ON
when distorted sound is
output through the subwoofer.
Press
% or fi to select low cut filter ON or
OFF.
MEMO:
• The initial setting is “
OFF
”.
• If the SUBWOOFER is set to “
OFF
” in the
SUBWOOFER ON/OFF setting mode, the low cut
filter cannot be set.
FRONT speakers distance setting
mode
Sets the distance from the FRONT speakers to the
listening position.
Press
% or fi to set the distance of the
FRONT speakers from the main listening
position (within a 30 foot range).
MEMO:
• The initial setting is 10 ft.
• One step equals about 1ft.
CENTER speaker distance setting
mode
The center speaker is normally placed directly in front of
the listening room and is thus closer to the listening
position than the Front speakers. This means that the
sound from the center speaker will be heard before the
Front speakers. To prevent this, set the center speaker
distance setting to delay the sound from the center
speaker so that the sound from the Front and center
speakers will be heard at the same time.
Press
% or fi to set the distance of the
CENTER speaker from the main listening
position (within a 30 foot range).
MEMO:
• The initial setting is 10 ft.
• When “
C*
” is selected in SPEAKERS setting mode,
the center distance cannot be set.
• One step equals about 1 ft.
Preparations