Pioneer DEH-P88RS-II - Manual (Page 54)

Operation modes
This unit features two operation modes: the 3-
way network mode (NW) and the standard
mode (STD). You can switch between modes
as desired. Initially, the DSP setting is set to
the standard mode (STD). (Refer to Switching
the DSP setting mode on page 9.)
! The 3-way network mode (NW) lets you cre-
ate a 3-way multi-amp, multi-speaker sys-
tem with separate speakers for
reproduction of high, middle and low fre-
quencies (bands), each driven by a dedi-
cated power amp. The 3-way network mode
provides network and time alignment func-
tions, two functions essential for a multi-
amp, multi-speaker system, to enable pre-
cise control over settings for each fre-
quency range.
! The standard mode (STD) lets you create a
4-speaker system with front and rear speak-
ers, or a 6-speaker system with front and
rear speakers and subwoofers.
Important
Even when the battery is disconnected or the mi-
croprocessor is reset, this unit
’s audio setting re-
mains in the memory for at least one day. If you
want to reset the audio setting, refer to Resetting
the audio functions on page 73.
Operation mode marks
This manual uses the following marks to make
the description clear.
: This mark indicates a function only in
NW mode or an operation in NW mode.
: This mark indicates a function available
only in STD mode or an operation in STD
mode.
! The functions and operations which do not
carry either mark are commonly used in
the NW and STD modes.
3-way network mode
Adjusting the audio easily
By carrying out the following settings/adjust-
ments in the order shown, you can create a fi-
nely-tuned sound field effortlessly.
1 Using the position selector (POSI)
2 Auto TA and EQ (auto-time alignment and auto-
equalizing)
3 Using balance adjustment ( BAL)
4 Recalling equalizer curves
Adjusting the audio finely
By carrying out the following settings/adjust-
ments in the order shown, you can create a fi-
nely-tuned sound field effortlessly.
1 Adjusting the time alignment (Low-Lch)
2 Adjusting network (NW 1, NW 2, NW 3)
3 Adjusting equalizer curves (EQ 1)
4 Adjusting 16-band graphic equalizer (EQ 2)
Standard mode
Adjusting the audio easily
The following functions let you easily adjust
your audio system to match the car interior
acoustic characteristics, which vary depend-
ing on the type of car.
1 Using the position selector (POSI)
2 Auto TA and EQ (auto-time alignment and auto-
equalizing)
3 Using balance adjustment ( F/B)
4 Recalling equalizer curves
Adjusting the audio finely
By carrying out the following settings/adjust-
ments in the order shown, you can create a fi-
nely-tuned sound field effortlessly.
1 Using subwoofer output (SW 1)
2 Adjusting subwoofer settings (SW 2)
Audio Adjustments
En
54
Section
12