Pioneer AVD-W8000 - Manual (Page 27)

26
ENGLISH
ESPAÑOL
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
Before Installing the Unit
• This unit is designed for vehicles with a 12-volt battery and negative grounding. Before
installing the system (especially in a recreational vehicle, truck or bus), check the battery
voltage.
• Disconnect the negative (–) terminal of the battery to avoid the risk of a short circuit.
To Prevent Damage
• When disconnecting a connector, pull the connector itself. Do not pull the lead, as you
may pull it out of the connector.
• When the unit is installed in vehicles that do not have an ACC (accessory) position on
the ignition (as shown in Fig. 2), be sure to connect the red lead of the unit to the termi-
nal controlled by the ignition switch ON/OFF position. If you do not, the vehicle battery
may be drained.
ACC ON
S
T
A
R
T
O
FF
ON
S
T
A
R
T
O
FF
Fig. 1
Fig. 2