Pioneer AVD-W6210 - Manual (Page 26)

Connecting the Power Cable
25
Connecting the System
Power cable
Fuse resistor
Light green
Used to detect the ON/OFF status of the parking
brake. This lead must be connected to the power
supply side of the parking brake switch.
Parking brake switch
Power supply side
Ground side
Fuse holder (4 A)
Hide-away Unit
Violet/White (Refer to page 29.)
Yellow
To the terminal always supplied with power regard-
less of ignition switch position.
Connecting method
Clamp the parking
brake switch power
supply side lead. Clamp firmly
with needle-nosed
pliers.
Red
To the electric terminal controlled by the ignition
switch (12 V DC) ON/OFF.
Do not connect this lead to power source terminals
to which power is continuously supplied. If the lead
is connected to such terminals, the battery may be
drained.
Black (ground)
To vehicle (metal) body.
Fuse resistor
Note:
• The position of the parking brake switch
depends on the vehicle model. For details,
consult the vehicle Owner’s Manual or
dealer.