Pioneer BDP-170-W - Manual (Page 51)

51
En
08
Multi-channel sound is not
output.
Is the audio output of the
connected AV receiver or
amplifier, etc., properly set?
Read the operating instructions for the connected AV receiver or
amplifier and check the audio output settings of the AV receiver or
amplifier.
Is multi-channel sound
selected?
Use the menu screen or AUDIO to switch the disc’s sound to multi-
channel.
Noise can be heard when
outputting DTS Digital Audio
signals from the DIGITAL
OUT
terminal.
Is the connected AV receiver
or amplifier compatible with
DTS Digital Surround?
If an AV receiver or amplifier that is not compatible with DTS Digital
Surround is connected to the DIGITAL OUT terminal, set Digital
Output
to PCM (page 37).
192 kHz or 96 kHz digital
audio signals cannot be
output from the DIGITAL
OUT
terminal.
• Copyright-protected audio is converted to 48 kHz or less before
output.
• Set Max Sampling Frequency to 96KHz or 192KHz (page 37).
Secondary audio or
interactive audio is not
output.
Is HDMI Audio Out properly
set?
When listening to the sound from an HDMI OUT terminal, set HDMI
Audio Out
to PCM (page 38).
Are Digital Output properly
set?
When listening to the sound from an DIGITAL OUT terminal, set
Digital Output
to Re-encode or PCM (page 37).
After a disc is inserted,
Loading
stays displayed and
playback does not start.
Are there too many files
recorded on the disc?
When a disc on which files are recorded is inserted, depending on the
number of files recorded on the disc, loading may take several dozen
minutes.
 is displayed in file names,
etc.
The characters that cannot be displayed on this player are displayed in
.
A message indicating low
memory appears while
playing a BD-ROM disc.
• Connect a USB device (page 18).
• Erase the data stored on the connected USB device from BUDA
Setup
(page 41).
Problem Check Remedy
BDP-170_72-BDP170-GBRB1_En.book 51 ページ ２０１４年３月２８日 金曜日 午前９時２６分