Pioneer DCS-580 - Manual (Page 38)

Other connections 10
38
En
3 Use
/ to select the setting you want.
• VOL.C OFF – This unit does not control the
volume of the flat screen TV.
• VOL.C ON – When this unit is switched to
one of the inputs that use the flat screen TV
(
DVD, or another one of functions below),
the volume on the flat screen TV is muted
so only sound from this system is heard.
4 Assign any input source connected to the
flat screen TV to the corresponding input
number.
Use
/ to select the source (DVD, LN1/2/3
( LINE 1/2/3) or USB), then
/ to select the
input number.
This matches this unit’s input source with a
numbered video input on the flat screen TV.
1
For example, select the LN1 PDP3, LN2 PDP3
or LN3 PDP3 setting if the video output of your
line component is connected to video input 3
on the flat screen TV.
TVTN switches the flat
screen TV to its built-in tuner and NONE leaves
the flat screen TV input as is (no switching
takes place).
5 When you’re finished, press ENTER.
Switching on the SR+ mode
1 Press SHIFT+SR+ on the remote.
2 Use / to select SR+ ON then press
ENTER.
To switch SR+ control off, select
SR+ OFF.
• If you disconnect the SR+ cable or switch
the flat screen TV off while SR+ is on, the
SR+ ON setting remains.
• The SR+ setting is maintained even after
switching this system into standby then
back on. Automatic muting will be effective
when this system is switched on.
Note
1 The PDP5 input may be called ‘PC Input’ (or similar) on your flat screen TV.
DCS-580_EN.book 38 ページ ２００８年２月２９日 金曜日 午後８時４１分