Pioneer RMX-1000-M - Manual (Page 16)

16 En
Frequency
SCENE FX control Sets the cutoff frequency of the low pass filter.
SUB PARAMETER 1
control
Sets the echo sound’s delay time.
SUB PARAMETER 2
control
Applies a modulation effect to the output.
CRUSH ECHO
This function creates a sound as if the input sound were crushed and
passes it through the filter and echo before outputting it.
The echo is output several times according to the multiplying factor of
the input sound’s beat, with the delay sound gradually attenuating.
Time
Cycle SCENE FX
control
SCENE FX control Sets the degree by which the input sound is crushed.
SUB PARAMETER 1
control
Sets the echo sound’s delay time.
SUB PARAMETER 2
control
Applies a modulation effect to the output.
SPIRAL DOWN
This function adds a reverberation effect to the input sound.
When the delay time is changed, the pitch changes simultaneously.
Input sound turned off
Time
Fade-out
1 beat
SCENE FX control Sets the SPIRAL’s delay time.
SUB PARAMETER 1
control
Sets the echo sound’s delay time.
SUB PARAMETER 2
control Sets the amount of pitch shifting by which the pitch is
decreased.
REVERB DOWN
This function adds a reverberation effect to the input sound.
Level
Direct sound
Early reflected sound
Reverberations
Time
SCENE FX control Use this to set the degree of the reverb effect.
SUB PARAMETER 1
control
Use this to set the degree of the reverb effect.
SUB PARAMETER 2
control
Sets the cutoff frequency of the low pass filter.
Types of ISOLATE FX effects
ISOLATOR
This function allows you to split the input sound into three bands – low,
mid, and high – and adjust the audio level for the respective bands.
LOW control Adjusts the audio level of the low frequencies.
MID control Adjusts the audio level of the mid frequencies.
HI control Adjusts the audio level of the high frequencies.
CUT/ADD
CUT: When turned counterclockwise
This function allows you to adjust the audio level of the bass drum
detected in the input sound and the manual filter’s cutoff frequency.
LOW control
Adjusts the audio level of the bass drum detected in the
input sound.
MID control
Applies the sound other than the bass drum detected in
the input sound to the high pass filter.
HI control
Applies the sound other than the bass drum detected in
the input sound to the low pass filter.
Bass drum
Bass drum
Bass drum
Frequency
Bass drum
Bass drum
Bass drum
ADD: When turned clockwise
This function lets you apply a 1/8-beat delay sound according to the
multiplying factor of the input sound’s beat.
LOW control Adjusts the audio level of the low frequency delay sound.
MID control Adjusts the audio level of the mid frequency delay sound.
HI control
Adjusts the audio level of the high frequency delay
sound.
1/1 beat
1/2 beat
1/4 beat
1/8 beat
Time