Pioneer AVG-VDP1 - Manual (Page 31)

Troubleshooting
Symptom Cause Action (See)
Power doesnt
turn on.
The unit
doesnt oper-
ate.
Leads and con-
nectors are incor-
rectly connected.
Confirm once more
that all connec-
tions are correct.
The fuse is
blown.
Rectify the reason
for the fuse blow-
ing, then replace
the fuse. Be very
sure to install the
correct fuse with
the same rating.
Noise and other
factors are caus-
ing the built-in
microprocessor
to operate incor-
rectly.
Press RESET. (Page
6)
There is no
sound.
Volume level is
low.
Cables are not
connected cor-
rectly.
Connect the cables
correctly.
The volume level
is low.
Adjust the volume
level.
Error messages
When you contact your dealer or your nearest
Pioneer Service Center, be sure to record the
error message.
Direction of G sensor is incorrect. Power off
the system and check the installation. After
checking, please re-boot the system and press
OK.
Installation direction of this unit is incorrect.
After reinstalling this unit correctly, touch OK.
Vibration of the unit has been detected.
Please power off the system and check the
installation. After checking, please re-boot
the system and press OK.
Vibration of this unit has been detected.
After changing the installation position of this
unit, touch OK.
Gyro Sensor error. Please consult your dealer
or Pioneer Service Center.
Gyrosensor error.
Please contact your dealer or Pioneer Service
Center after touching OK.
Memory error. Please re-boot your system. If
error continues, please consult your dealer or
Pioneer Service Center.
Memory error.
Press RESET. If error continues, please consult
your dealer or Pioneer Service Center.
Hardware error. Please contact your dealer or
Pioneer Service Center.
Hardware error.
Press RESET. If error continues, please consult
your dealer or Pioneer Service Center.
GPS Antenna is not connected. Please check
your connection.
GPS antenna is not connected.
Connect GPS antenna correctly.
GPS Antenna error. Please contact your dealer
or Pioneer Service Center.
GPS antenna error.
Press RESET. If error continues, please consult
your dealer or Pioneer Service Center.
Speed pulse wire is not connected. Accuracy
cannot be ensured without speed pulse.
Please be sure that the speed pulse wire is cor-
rectly connected to the system.
Speed pulse cord is not connected.
Connect the speed pulse cord after touching
OK.
Additional Information
En
31
English
Appendix